top of page

The ARGIE 15 was designed to be a versatile family fun boat. Essentially a 3 in 1 dinghy, she can be rowed, sailed or powered by an outboard motor of up to 7,5kw output. She is more than the normal 3 in 1 dinghy in that it was considered from the start that she may be used as a camp cruiser. Most dinghies have no areas long enough for an adult to stretch out full length for sleeping but the ARGIE 15 has 1,9m of clear length, sufficient for most people. The addition of removable slatted floorboards to your boat will lift you out of any water lying in the bottom while sleeping. A canvas or plastic sheet over the boom and tied to eyes along the gunwhales will give protection from the elements. The result is a minimum cruiser for use on protected waters.

She has also been designed to make maximum use of the advantages of plywood to give a light and easily managed boat which is well within the capabilities of the average DIY enthusiast. The construction method used is stitch and glue which eliminates most of the framing normally used in boat construction and results in very light structural weight. The weight of a completed hull is approximately 60kg, making her suitable for car topping on extended roof racks. She will, however be more easily handled with a trailer. http://www.dixdesign.com/argie15.htm

 

500 Terry Francois Street

San Francisco, CA  94158

 

info@mysite.com

Tel: 123-456-7890

Fax: 123-456-7890

to About
to Work
to Services

    About the design    

    Contact    

Construction journal for a 15 foot sailing dinghy.

 

I am building a sailing dinghy following Dudley Dix' Argie 15 plans. I like this design because it appears to be a very stable shape with plenty of versatility for cruising and messing about in sheltered waters. The following is a documentation of the build process.

    Work    

    Work    

Success! Message received.

bottom of page